Kubota M105S, Workshop Manual

Page: 410 / 561

8-S22
M105S, WSM HYDRAULIC SYSTEM
Adjusting Top Link Bracket
1. Measure the clearance (A) between the stopper (3) and top link
bracket (1).
If the clearance is not within the factory specifications, adjust with
the shims (4) between the stopper (3) and top link bracket (1).
(Reference)
• Thickness of shim (4) : 0.5 mm (0.020 in.), 1.0 mm (0.040 in.)
W1031081
Floating Range Check
1. Attach the weight (3) of approx. 490 N (50 kgf, 110 lbs) to the end
of the lower links.
2. Attach the test bar (1) to the top link bracket (2).
3. Start the engine and set the speed at 1000 min
-1
(rpm).
4. Move the draft and position control lever all the way down.
5. Press the test bar (1) downward until the top link bracket (2)
comes in contact with the stopper.
6. Slowly shift the draft control lever (4) upward until the lift arms
begin to rise. Then slowly shift the draft control lever (4)
downward until the lift arms begin to down, measure the travel
distance L of the draft control lever (4) on the lever guide (5).
7. If L is shorter than 15 mm (0.591 in.), shorten the draft control
rod.
W1031315
Clearance (A) Factory spec.
7.5 to 8.5 mm
0.295 to 0.335 in.
(1) Top Link Bracket
(2) Torsion Bar (3) Stopper
(4) Shim
Floating range L Factory spec.
More than 15.0 mm
0.59 in.
(1) Test Bar
(2) Top Link Bracket
(3) Weight
(4) Draft Control Lever (5) Lever Guide
L : Floating Range
KiSC issued 03, 2007 A