KTM 300 EXC, Repair Manual

Page: 178 / 289

18 ENGINE
176
308148-11
–
Mount screws
6
and tighten in a crisscross pattern.
Guideline
Screw, clutch spring retainer M5 6 Nm (4.4 lbf ft)
308154-10
–
Using a straightedge and the special tool, check the spring washers for distortion.
Feeler gauge (59029041100) ( p. 275)
Spring washer distortion 0… 0.10 mm (0… 0.0039 in)
» If the specified value was not attained:
–
Remove screws
6
and mount the spring retainer with marking
Y
.
–
Using a straightedge and the special tool, check the spring washers for distortion.
Feeler gauge (59029041100) ( p. 275)
Spring washer distortion 0… 0.10 mm (0… 0.0039 in)
» If the specified value was not attained:
–
Remove screws
6
and mount the spring retainer with marking Z .
–
Using a straightedge and the special tool, check the spring washers for distortion.
Feeler gauge (59029041100) ( p. 275)
Spring washer distortion 0… 0.10 mm (0… 0.0039 in)
» If the specified value was not attained:
–
Change the clutch facing discs.
18.5.16 Installing the clutch cover
302981-10
–
Apply a thin layer of sealing compound in area
A
on both sides.
Loctite ® 5910
308147-11
–
Mount the dowels.
–
Mount clutch cover gasket
1
.
308146-11
–
Position the clutch cover. Mount and tighten screws
2
.
Guideline
Screw, clutch cover M6 10 Nm (7.4 lbf ft)