16
BRAKE SYSTEM
107
602759-10
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
1
.
–
Remove cover
2
with membrane
3
.
–
Manually press the brake caliper toward the brake disc to push back the brake pis-
tons. Ensure that brake fluid does not flow out of the brake fluid reservoir, extract-
ing it by suction if it does.
Info
Make sure when pushing back the brake pistons that you do not press the
brake caliper against the spokes.
101376-10
–
Remove cotter pins
4
, pull out pin
5
, and remove the brake linings.
–
Clean the brake caliper and brake caliper support.
100397-01
–
Check that leaf spring
6
in the brake caliper and sliding plate
7
in the brake
caliper support are seated correctly.
100398-10
–
Insert the new brake linings, insert the pin, and mount the cotter pins.
Info
Always change the full set of brake linings.
–
Operate the hand brake lever several times until the brake linings are lying correctly
against the brake disc and there is a pressure point.
602759-11
–
Correct the brake fluid quantity to level
A
.
Guideline
Dimension
A
(brake fluid level below
top edge of container)
5 mm (0.2 in)
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Wash off overflowed or spilled brake fluid immediately with water.
