Krone Big Pack 127 / MultiCut, Operating Manual, Page: 64 / 132

VI - 10
Settings
6.10 Adjusting the Flywheel Cleaning Mechanism
(only Big Pack 88)
Even small deposits of dirt in the interior of the flywheel
(1) can lead to imbalances. The setting of the plastic
bar (2) should therefore be checked regularly. If the gap
between the flywheel and the plastic bar is too large,
undo the nuts (5) on the bracket (4) and slide the plastic
bar in the slots up towards the flywheel mass. Tighten
up the nuts again.
BP380-7-069
2
1
3
4
The spring (23) is responsible for bringing the back
holder rake into its swing position again after the feeder
insertion (over the anvil (15) and the threaded rod (13)).
The anvil (15) therefore has to arrive at the adjust screw
(24).
The arrange measure is swing length “C” = 140 mm .
• The tension of the swing should be increased, if
-
the end position of the back holder rake and the
anvil cannot be reached (see chapter 6.8.)
- the filling of the press channel's height is not
sufficient.
-> Badly filled baler corners mostly result due to
bad forms of swathe or onesided driving
conditions
• A too high tension of the spring may lead to
overload and finally to a blockade of the rake.
6.9 Setting the sensibility of the actuator
C
24
15
23
13
BP-VFS-093