Krone Big Pack 127 / MultiCut, Operating Manual, Page: 14 / 132

II - 4
Safety
7. Liquids escaping under high pressure (hydraulic
oil) can penetrate the skin and cause serious
injury! Seek medical help immediately should
injuries occur! Risk of infection!
8. Before working on the hydraulic system, lower the
implement, depressurize the system and switch
off the engine!
2.2.8 Tyres
1. When working on the tyres, make sure that the
implement has been safely lowered and secured
against rolling (wheel chocks).
2. Installing wheels and tyres requires adequate
knowledge and suitable tools!
3. Repair work on the tyres and wheels should be
done by specially trained personnel using
appropriate installation tools only!
4. Check tyre pressure regularly! Inflate the tyres to
the recommended pressures!
2.2.9 Maintenance
1. Repair, maintenance and cleaning work as well as
the rectification of malfunctions may only ever be
carried out when the drive is switched off and the
engine is at a standstill!
- Remove the ignition key! Pull the parking brake
for the balancing weight.
2. Regularly check that nuts and bolts are properly
seated and tighten if necessary!
3. When doing maintenance work to a raised
implement, always use suitable means to secure
it against falling.
4. When replacing working tools with cutting edges,
use suitable tools and gloves!
5. Dispose of oils, greases and filters according
to regulations!
6. Always disconnect the power supply before
working on the electrical system!
7. If protective devices and guards are subject to
wear, check them regularly and replace them in
good time!
8. When doing electrical welding on the tractor and
attached implements, disconnect the alternator
and battery cables!
9. Replacement parts must at least comply with the
technical requirements set by the manufacturer of
the implements!
This is guaranteed when using genuine KRONE
replacement parts!
10. Only use nitrogen for filling pneumatic
accumulators - Risk of explosion!
2.2.10 Unauthorized Modification and
Manufacture of Replacement Parts
Modifications to the machine are permitted only with
the prior approval of the manufacturer. Genuine
replacement parts and accessories authorized by the
manufacturer help ensure safety. Use of other parts
may void liability for damage which results.
2.2.11 Prohibited Modes of Operation
The operational safety of the machine is guaranteed
only if it is used for its intended purpose in accordance
with the General Information chapter of the operating
manual. The limit values listed in the data charts
should not be exceeded under any circumstances.