Krone Big Pack 127 / MultiCut, Operating Manual, Page: 47 / 132

V - 1
Working with the Big Pack Baler
5. Working with the Big Pack Baler
5.1 Special Notes on Safety
• The following always applies for all maintenance, repair and adjustment work: switch off the
PTO shaft, switch off the engine and remove the ignition key. Apply the flywheel brake.
• Keep a safe distance from all moving parts on the big pack baler during operation. This
applies in particular to the crop collection mechanism.
• Only put the big pack baler into operation once all protective devices have been fitted and
are in a proper operating condition.
• Only free blockages when the machine is at a standstill. Switch off the engine and remove
the ignition key. Apply the flywheel brake.
• In dangerous situations switch off the PTO shaft and bring the big pack baler to a standstill
immediately.
• Never run the big pack baler without an operator on the tractor.
5.2 Basic Setup for the Big Pack Baler
5.2.1 Pick Up
Raise the pick up when driving into a curve and when driving backwards!
Adjusting the Working Height
To adjust the height of the pick up, raise it and lock with the shut-off tap on the right hand
side of the machine to secure it from unintentional rolling away.
The adjustment of the working height is made at the
feeler wheels (3) on both sides of the pick up. To make
the adjustment raise the pick up and secure. Pull out
the spring pin (2) and set the feeler wheels in the
desired position on the bar with holes (1). Secure the
feeler wheels again using the spring pin.
Make sure that the feeler wheels on both
sides of the pick up are in the same po-
sition on the bar with holes.
BP380-7-035
2
1
3