Krone Big Pack 127 / MultiCut, Operating Manual, Page: 45 / 132

IV - 9
Comfort Controls
4.6.6 Blade Check on the Cutting Mechanism (Special Equipment)
off-.blade contr. on
....... off !.......
or
off-.blade contr. on
....... on !........
You can switch from "
ON
" to "
OFF
" by pressing button
or by switching button from "
OFF
" to "
ON
".
You can return to the programme by pressing button
1
.
A flashing indicator light on button (8) indicates that the
tension bolt in the blade safety mechanism is faulty.
- Alarm-No.:....0000
Tensioner faulty!!..
4.6.5 Alarm Messages
Alarm messages appear in the display when irregulari-
ties are picked up by the on-board computer. Alarm
messages always take preference. They interrupt the
current display immediately.
A horn sounds in the control box at the same time as
the alarm message appears. The horn can be switched
off using button
3
. If button
3
is pressed
again, the alarm message in the display disappears and
the previously shown message reappears. Some faults,
e.g.
"BALING THRUST EXCEEDED" , correct themsel-
ves.
Übersicht der Alarmmeldungen siehe Anhang A 1.4
Alarm- und Fehlermeldungen bei der Big Pack 88 /
127 / 128.
4.7 Sonstiges
Depending on the operating status, the following messages
appear in the display when button
8
is pressed:
Hinweis zur Fehlersuche, zu Tests und
speziellen Einstellungen entnehmen Sie
bitte dem Anhang A1!
Prog Quit
#
1 2 9 0
3 4
BP-VFS-079
- Alarm-Nr.:....0000
Fadenspanner defekt!
13
5 6 8 7
P
max
Prog Quit
#
1 2 8 9 0
3 4
BP-VFS-080
aus Messerkontr. ein
....... aus !.......
5 6 8 7
P
max
8