Krone Big Pack 127 / MultiCut, Operating Manual, Page: 55 / 132

VI - 1
Settings
6. Settings
6.1 Special Notes on Safety
• The following always applies for all maintenance, mounting, repair and adjustment work:
switch off the PTO shaft. Switch off the engine and remove the ignition key. Apply the
flywheel brake.
• Only put the big pack baler into operation when all protective devices have been attached
and are in a proper operating condition.
• In dangerous situations stop the PTO shaft and bring the big pack baler to a standstill
immediately.
• Never run the big pack baler without an operator on the tractor.
• When working under the machine or on the needles in the baling channel, the needle carrier
must be secured against falling down. Danger of injury!
6.2 Adjusting the Needles
Carry out all adjustments to the needles without any twine threaded!
6.2.1 Lateral Adjustment of the Needles
Insert the needles (1) centrally between the clamping
brackets and the needle yoke, turn them towards the
needle slits and screw tight with screws (2). To be able
to carry out the adjustment, the binding process is
initiated manually and the needle yoke manually turned
up in the working direction at the flywheel mass. When
raised, the needles must just laterally touch the left and
right hand sides of the knotter frames. To correct the
lateral distance, the screws (2) are undone and the
needles laterally positioned with the adjusting screws
(3). Always make sure that the screws are all tightened
up firmly again after making the adjustment.
BP380-7-053
1
2
3
2