KROHNE optiplex 1300 c, Handbook

Page: 4 / 95

Handbook OPTIFLEX 1300 C
OPTIFLEX 1300 C 4
0. Introduction
0.1 General
0.1.1 Description of device
The OPTIFLEX 1300 C gauge is designed solely for measuring the distance, level, interface, mass and
volume of liquids, pastes, slurries, granulates and powders.
OPTIFLEX can form part of an overfill protection system as defined in WHG if ordered with the appropriate
options.
The OPTIFLEX 1300 C is KROHNE's latest 2-wire TDR (guided-pulse) level-measurement gauge.
Using its new third-generation electronics, the gauge emits signals with a small pulse width, large bandwidth
and short signal rise and fall times. When the gauge processes the signal, a higher signal amplitude is
achieved which ultimately results in sharper resolution and higher accuracy.
TDR gauges use a probe to guide a signal to the surface of the measured product(s). With a choice of 6
probes, OPTIFLEX is capable of measuring most materials in very difficult conditions.
The OPTIFLEX 1300 C can detect and measure thin interfaces-not much thicker than a 50 mm film of oil on
water in a large tank. This is a new-generation level meter with a wizard-driven setup, fully-potted electronic
subassemblies, an online help functions.
It is provided with a pictorial quick setup. You will not normally need this Handbook to install, set up and
operate the device. All menu items have an on-screen help function that is activated 15 seconds after the last
input. In the unlikely event of a failure, error icons appear on-screen. Clicking on the error icon in the
PACTware device tool manager software or by looking in the error record menu item in program mode using
the device screen wizard displays an error description, which normally is sufficient to rectify the problem. Only
in severe cases will you need to consult the error records.
0.1.2 Legal matters
Authorized personnel
Installation, assembly, commissioning and servicing must only be undertaken by KROHNE-trained personnel.
Maintenance which is considered relevant to safety in the sense of explosion protection must only be carried
out by the manufacturer, his agents or under the supervision of experts.
Liability
Responsibility as to suitability and intended use of these devices rests solely with the user. Improper
installation and operation may lead to loss of warranty. In addition, KROHNE Group's Standard General
Conditions of Sale and Delivery, found on the back of the invoice and forming the basis of the purchasing
contract, are applicable.
Special codes and regulations apply to its use in hazardous areas.
General limitation on liability
Unless otherwise expressly set forth in the Standard Terms and Conditions of Sale and Delivery, the Seller is
only liable for damages, whatever their legal basis is, in case they are based on willful action or gross
negligence. This limitation on liability does not apply in the event the Buyer raises claims relating to personal
injury or damages to property according to the product liability law based on a defect of the delivered goods.
Any advice given by the Seller, in particular regarding the application of the delivered goods, shall only commit
the Seller if given or confirmed in writing.
Returning the device
If you need to return the level gauge to the manufacturer or supplier, please read to the instructions and
complete the form given in the appendix.
Warranty
Please consult KROHNE’s General Terms and Conditions for information on guarantee and liability.