K-CONFIG –
The Driver Manager – Getting Started
49
3.
Click the
Test Command
button:
If the connection type between the room
controller device and the PC was not yet
established, the connection window will
appear and you should select the connection
method (in this specific example, the
RC-74DL
is connected to the PC via the
Ethernet) and click Connect (see
after that the Device Ports window appears
(see
).
Figure 75: Testing Serial Commands –Connecting the PC to
the Room Controller
If the room controller device is connected, the
Device Ports window appears and you will
need to select the port to which the controlled
device is connected (see
).
Figure 76: Testing Serial Commands –Selecting a Device Port
4.
Select the port to which the controlled device is connected to the room controller (for example, the projector is
connected via RS-232 Terminal Block 1 to the
RC-74DL
room controller) and click OK.
Note that if the controlled device is connected to the Ethernet, the following window appears. Verify the details
and then click OK.
Figure 77: Testing Serial Commands –Ethernet Settings for Controlled Device
