146
K-CONFIG - Adding Actions to a Trigger
9.10
Adding Sub Routines
Sub routines are enabled once a sub routine
trigger is defined (see
Section 8.7
). After
setting the sub routine trigger, you can add the
sub routine trigger to any other trigger. This is
helpful for using if you need to repeat a
sequence of actions several times within a
trigger or repeat the same sequence of action
in several triggers.
Figure 274: Sub Routines – Select a Sub Routine
9.11
Site Control Message
The
Site Control Message
action is used to send messages to
Site-CTRL
SW application and display them.
Select the
Port
, the
Query
and the
Status
. If relevant, the status is set so that it fits the Site Control filtering
categories. The message is typed as required.
Figure 275: Site Control Message – Select the Query Event
Note that the
Status
sets the level of the displayed message so that when in
Site-CTRL
messages can be filtered
according to their levels of risk or importance this message will also be filtered in accordance with the
Site-CTRL
filtering levels.
Note that if you select the LampHour query you need be sure that "Send parsed value" is checked, to allow the
SiteCTRL main screen to show the Lamp Hour life in percentage.
