Korenix JetNet 5228G Series, User Manual

Page: 570 / 658

Command Line Interface
4-260
4
lldp admin-status
This command enables LLDP transmit, receive, or transmit and receive mode on the
specified port. Use the
no form to disable this feature.
Syntax
lldp admin-status { rx-only | tx-only | tx-rx }
no lldp admin-status
• rx-only - Only receive LLDP PDUs.
• tx-only - Only transmit LLDP PDUs.
• tx-rx - Both transmit and receive LLDP Protocol Data Units (PDUs).
Default Setting
tx-rx
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
lldp notification
This command enables the transmission of SNMP trap notifications about LLDP
changes. Use the
no form to disable LLDP notifications.
Syntax
[ no ] lldp notification
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This option sends out SNMP trap notifications to designated target stations at
the interval specified by the lldp notification-interval command
(page 4-257). Trap notifications include information about state changes in
the LLDP MIB (IEEE 802.1AB), or organization-specific LLDP-EXT-DOT1 and
LLDP-EXT-DOT3 MIBs.
• SNMP trap destinations are defined using the snmp-server host command
(page 4-72).
• Information about additional changes in LLDP neighbors that occur between
SNMP notifications is not transmitted. Only state changes that exist at the time
Console(config)#interface ethernet 1/1
Console(config-if)#lldp admin-status rx-only
Console(config-if)#