Korenix JetNet 5228G Series, User Manual

Page: 182 / 658

Configuring the Switch
3-136
3
Web – Click Port, Port/Trunk Broadcast Control. Set the threshold, mark the
Enabled field for the desired interface and click Apply.
Figure 3-81 Port Broadcast Control
CLI – Set the threshold, then enable broadcast control on any interface. The
following sets broadcast control threshold at 500 kbytes per second, and then
enables broadcast storm control for port 1.
Console(config)#broadcast byte-rate 100 level 5 4-178
Console(config)#interface ethernet 1/1 4-172
Console(config-if)#switchport broadcast 4-178
Console(config-if)#end
Console#show interfaces switchport ethernet 1/1
4-182
Information of Eth 1/1
Broadcast Threshold: Enabled, scale:100K level:5 octets/second
LACP Status: Disabled
Ingress Rate Limit: Disabled, scale:10M level:1
Egress Rate Limit: Disabled, scale:10M level:1
VLAN Membership Mode: Hybrid
Ingress Rule: Enabled
Acceptable Frame Type: All frames
Native VLAN: 1
Priority for Untagged Traffic: 0
GVRP Status: Disabled
Allowed VLAN: 1(u),4093(t),
Forbidden VLAN:
Private-VLAN Mode: NONE
Private-VLAN Host-association: NONE
Private-VLAN Mapping: NONE
802.1Q-tunnel Status: Disable
802.1Q-tunnel Mode: NORMAL
802.1Q-tunnel TPID: 8100(Hex)
Console#