Korenix JetNet 5228G Series, User Manual

Page: 506 / 658

Command Line Interface
4-196
4
Example
The following shows mirroring configured from port 6 to port 11:
Rate Limit Commands
This function allows the network manager to control the maximum rate for traffic
received on an interface. Rate limiting is configured on interfaces at the edge of a
network to limit traffic into the network. Packets that exceed the acceptable amount
of traffic are dropped.
Rate limiting can be applied to individual ports. When an interface is configured with
this feature, the traffic rate will be monitored by the hardware to verify conformity.
Non-conforming traffic is dropped.
rate-limit
This command define the rate limit for a specific interface. Use the no form to
restore the default status of disabled.
Syntax
rate-limit { input | output } scale { 1k | 10k | 100k | 1m | 10m } level level
no rate-limit { input | output }
• input – Input rate limit
• output – Output rate limit
• scale – The traffic rate limit scale. (Options: 1K, 10K, 100K, 1M, or 10M bytes
per second)
• level – The traffic rate limit level. (Range: 1-127)
Default Setting
Status: Disabled
Scale: 10M bytes per second
Level: 1
Console(config)#interface ethernet 1/11
Console(config-if)#port monitor ethernet 1/6 rx
Console(config-if)#end
Console#show port monitor
Port Mirroring
-------------------------------------
Destination port(listen port):Eth1/11
Source port(monitored port) :Eth1/6
Mode :RX
Console#
Table 4-60 Rate Limit Commands
Command Function Mode Page
rate-limit Configures the maximum input or output rate for a port IC 4-196