Korenix JetNet 5228G Series, User Manual

Page: 507 / 658

Address Table Commands
4-197
4
Command Mode
Interface Configuration (Ethernet)
Command Usage
The scale and level are multiplied by one another to set the rate limit. For
example, to limit port traffic to 500K bytes per second, select the scale as
100K and set the level to 5.
Example
Address Table Commands
These commands are used to configure the address table for filtering specified
addresses, displaying current entries, clearing the table, or setting the aging time.
mac-address-table static
This command maps a static address to a destination port in a VLAN. Use the no
form to remove an address.
Syntax
mac-address-table static mac-address interface interface
vlan vlan-id [ action ]
no mac-address-table static mac-address vlan vlan-id
• mac-address - MAC address.
• interface
• ethernet unit / port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-12)
• vlan-id - VLAN ID (Range: 1-4094)
Console(config)#interface ethernet 1/1
Console(config-if)#rate-limit input scale 100k level 5
Console(config-if)#
Table 4-61 Address Table Commands
Command Function Mode Page
mac-address-table static Maps a static address to a port in a VLAN GC 4-197
clear mac-address-table
dynamic Removes any learned entries from the forwarding database PE 4-198
show mac-address-table Displays entries in the bridge-forwarding database PE 4-199
mac-address-table
aging-time Sets the aging time of the address table GC 4-200
show mac-address-table
aging-time Shows the aging time for the address table PE 4-200