Korenix JetNet 5228G Series, User Manual

Page: 479 / 658

Access Control List Commands
4-169
4
map access-list mac
This command sets the output queue for packets matching an ACL rule. The
specified CoS value is only used to map the matching packet to an output queue; it
is not written to the packet itself. Use the
no form to remove the CoS mapping.
Syntax
[ no ] map access-list mac acl_name cos cos-queue
• acl_name – Name of the MAC ACL. (Maximum length: 16 characters)
• cos-queue – Port CoS queue. (Range: 0-3)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
• You must configure an ACL before you can map a CoS queue to the rule.
• A packet matching a rule within the specified ACL is mapped to one of the
output queues as shown below.
Example
Related Commands
queue cos-map (4-279)
show map access-list mac (4-170)
Table 4-50 Egress Queue Priority Mapping
Priority 1,2 0,3 4,5 6,7
Queue 0 1 2 3
Console(config)#interface ethernet 1/2
Console(config-if)#map access-list mac steve cos 0
Console(config-if)#