Konica Minolta CM-M6, Instruction Manual

Page: 12 / 128

9
„ „
Conventions
This manual describes how to safely operate the CM-M6 using a specific procedure to perform measurement.
· Viewing Pages
Symbols used in this manual are explained below.
* Explanatory pages are constructed as follows. (The content of the explanatory illustration will differ from the
actual page.)
* Display screenshots used in the explanations may include different content and values, and may have a different
layout than the actual display.
86
3
En
vir
onment Set
tings/Other Set
tings
„
Annual Calibration Messages
As the time for periodic calibration approaches, the instrument shows a message reading “Regularly scheduled
device calibration is required. Please contact the nearest service center.” at start-up to recommend annual service
recalibration.
The annual calibration message can be turned OFF from the MENU.
Notes
Although the annual calibration message can be hidden, it is recommended to accept our recalibration
service.
Memo
Display of the annual calibration message is set to “ON (Display)” under the initial settings.
Operating Procedure Start the procedure from the <Setting> - <Calibration setup> screen.
1
Press [MENU].
The <Annual calibration> screen
is displayed.
Settings
„ {
OFF : Do not show the annual calibration message
even if the next calibration date is near.
„ { ON : Show the annual calibration message when the
next calibration date approaches.
2
Use [  ] or [  ] to move the cursor to select “OFF” or
“ON”.
Memo
If the annual calibration notification message is set to ON,
the annual calibration message will be displayed when the
specified day approaches. The date of the next calibration is
specified under the initial settings or during KONICA
MINOLTA calibration service (or maintenance) and cannot be
changed.
3
Press the [Confirmation] key.
The selection is confirmed and the screen returns to the
<Setting> screen .
Notes
If [ESC] is pressed without pressing the [Confirmation]
key, the settings will not be changed and the screen will
return to the <Setting> screen.
Calibration setup
Annual calibration
ON
Calibration interval
8 (hour)
Sample
0002 TARGET-2
Setting
Calibration setup
Annual calibration
ON
Calibration interval
8 (hour)
Sample
Setting
0002 TARGET-2
Annual calibration
OFF
ON
Next date
2016/01/01
„
Instrument Firmware Version
The version of the instrument firmware can be confirmed on the <Instrument info.> screen. For details, refer to
page 98 “Displaying the Instrument Information” in this manual.
Procedure
Indicates an
operating procedure.
Settings
Describes ranges and
provides
explanations
regarding settings for
the screen in
question.
Memo
Provides useful
information,
supplementary
explanations, and
similar details.
Notes
Provides essential
information for
correct operation of
the instrument.
Always read this
information before
operating the
instrument.
Start screen
Indicates the initial
screen from which
the operation is
commenced.
Screenshot
Indicates the state of
the screen when the
operation described
in the procedure to
the left is carried out.