Konica Minolta bizhub C35, Service Manual

Page: 168 / 330

DRAFT
Field Service V er. 1.0 Feb. 2010 10. SER V ICE MODE
129
bizhub C35
ADJUSTMENT
/ SETTING
10.5.12 Thick Mode
A. Use
• In order to prevent toner from clogging within the developer unit as a result of it being
driven at half-speed, select the timing for driving the developer unit at full speed for a
fixed length of time when thick paper is being fed.
Quality Mode: While printing on thick paper, printing is periodically paused, and the
developer unit is driven at full speed for a fixed length of time. Since
printing is paused, the quality is not affected; however, a standby time of
approximately 70 seconds occurs every 400 seconds or so of half-speed
operation.
Speed Mode: While printing on thick paper, only the drive of the developer unit periodi-
cally switches to full speed for a fixed length of time.
Since printing continues during full-speed drive, the print quality is
slightly affected, however the standby time is short.
B. Procedure
• The default setting is Quality Mode.
“Quality Mode” Speed Mode
10.5.13 Fine Line ADJ
A. Use
• Adjust how fine lines are reproduced by changing the applied voltage ( V C) to the electro-
static roller.
B. Procedure
• The default setting is 0.
-4 to 3
NOTE
• The administrator can also make this setting by selecting [Admin Set-
tings]
→
[Maintenance Menu]
→
[Printer Adjustment]
→
[Fine Line ADJ].
However, the adjustable range of the parameter is narrowed to -3 to 2.
10.6 Main Scan Adjust
10.6.1 Main Scan Page
A. Use
• Prints the test pattern used for the main scan adjustment.
B. Procedure
1. Call the Service Mode to the display.
2. Touch [Main Scan Adjust]
→
[Main Scan Page].
3. Select [Print], and touch [OK].
4. The test pattern is output.