Konica Minolta bizhub 25e, Field Engineering Manual

Page: 122 / 353

3-46
Attribute 3 ‑ Individual Autodialer Setting
(Equivalent to Memory Switch 012)
Switch
Initial
Setting
Adjust Usage/Comments
7 1 TTI clock type
0 : AM PM clock
1 : 24 hour clock
6 1 TTI calendar type bit 6 5
1 1 dd mm yyyy (default)
1 0 mm dd yyyy
0 1 yyyy/mm/dd
5 0
4 1 TTI transmit
0: No
1: Yes
NOTE
Turning TTI transmission
off may violate local or
federal regulations.)
When set at “0”, transmission of the TTI is disabled.
The TTI includes the followings:
•
Sender name
•
Sender’s fax number
•
Data & time, and number of pages
To set the individually transmission of them, see
Memory SW 016.
3 0 ECM response time
0: 3 sec
1: 4.8 sec
The time limit to receive the response signal for the
ECM post message.
2 0 ECM error retransmit time
0: 200 ms
1: 400 ms
The time limit before the ECM error is retransmitted.
1 0 Interval between DIS and DCS
0 0 0 ms 500 ms 1000 ms 1500 ms
Switch 1 0 0 1 1
Switch 0 0 1 0 1
Attribute 4 ‑ Individual Autodialer Setting
(Equivalent to Memory Switch 013)
Switch
Initial
Setting
Adjust Usage/Comments
7 0 ANSam detection
0 : Yes
1 : No
During the V8 handshake, if some noise disturbs the
handshake and an error occurs, set to “1”.
6 0 V. 34 transmission
0 : Yes
1 : No
Individual setting for V.34 transmission.
5 0 CSI / TSI / CIG transmit
0 : Yes
1 : No
When set at “1”, transmission of the CSI, TSI and
CIG signals are disabled.
4 0 ECM mode
0 : On
1 : Off
Determines ECM mode. ECM mode reduces docu-
ment memory and may lengthen transmission and
reception times.
3 0 Retransmit automatically when
receiving RTN / PIN signals
0 : Yes
1 : No
When set to “1”, retransmission disables automati-
cally if receiving RTN / PIN signals.
2 1 Factory use only —
1 0 Factory use only —
0 0 Factory use only —
Attribute 5 ‑ Individual Autodialer Setting
(Equivalent to Memory Switch 014)