Kollmorgen MMC Smart Drive Series, Hardware Manual

Page: 165 / 386

Kollmorgen - June 2014 163
MMC Smart Drive Hardware Manual
-
230V 1/3 PHASE MMC SMART DRIVE
7 230V 1/3 Phase MMC Smart Drive
The 230V MMC Smart Drive is available in both analog and digital interfaced versions,
with power ratings from .5kW through 3kW. This section describes these drives in
detail.
The following 230V MMC Smart Drive are available:
•
Single Phase analog and digital interfaced versions, with power ratings of .5kW,
1kW, and 2kW.
•
Three Phase analog and digital interfaced versions, with power ratings of .5kW,
1kW, 2kW, 3kW (digital interfaced only).
Features include:
• 230V, Single Phase drives available with power ratings of .5kW, 1kW, and 2 kW
• 230V, Three Phase drives available with power ratings of .5kW, 1kW, 2 KW, and 3
kW
• Can also operate on Single Phase power
• Built-in Regen circuitry (requires external Regen resistor)
• Optional Safe-off feature
• Drive firmware in user upgradeable Flash memory
• Serial port for communications with PC-resident PiCPro
• Internal switch to control a mechanical brake
• Green Power LED and yellow Diagnostic LED
• A primary feedback connector (F1), containing the following features:
• High density female DB-15 connector
• Supports the following feedback devices:
• Incremental Encoder (without halls, Enhanced Feedback models only)
• Comcoder Input (Incremental Encoder with halls, not on Enhanced Feed-
back models). Note that halls can be connected to F1 or F2, but not both.
• Stegmann Hiperface encoder
• High Resolution Resolver
• 1V p-p Sinewave Encoder
• Endat 2.1 (2.2 in future release)
• BiSS (Mode B)
• A secondary feedback connector (F2), containing the following features:
• High density female DB-15 connector
• This connector can support one of the following functions:
• Emulated F1 encoder output
• Comcoder Input (Incremental Encoder with halls). Note that on non-
Enhanced Feedback models, halls can be connected to F1 or F2, but not
both.