Koden MDC-7006, Installation Manual

Page: 82 / 160

Chapter 4 Setup after installation MDC-7000/7900 Series
4-22 0092669002-07
4.2.10 Changing formats of input/output ports of navigation devices, position
and ship speed (IEC 61162).
When the data is correctly input in each port and is not displayed on the display, the formats of signals
(IEC 61162) may be unmatched. In this case, display [INPUT] menu mentioned in 4.2.9, and confirm
that a mark is displayed at the intersection point of the input sentence and the input port. When a mark
is not displayed, set each format (baud rate) of input/output so as to match with those of connected
sensors with input sentences.
The baud rates are:
IEC 61162-1: 4800 bps
IEC 61162-2: 38400 bps
Default value per port is set as follows:
J3 (NAV): IEC 61162-2
J5 (EPFS): IEC 61162-1
J6 (SDME): IEC 61162-1
OP1 (GYRO): IEC 61162-2
OP2 (OTHER): IEC61162-1
GYRO and OTHER port will be displayed when JB-35 is connected to NAV (J3).
Example of change of setting: J3 port 38400 bps => 4800 bps
Press MENU
key to display “Menu”.
Select [MAINTENANCE] => [I/O] => [BAUDRATE] => [J3] => [4800] and set with ENT key.
4.2.10.1 Setting all I/O ports automatically
This radar can set the format of all I/O ports automatically by following procedure.
(1) Press MENU
key to display “Menu”.
[MAINTENANCE] => [I/O] => [BAUDRATE] => [AUTO SETUP] => [GO], and press ENT key.
About 30 sec. later all I/O ports can be set by input signals connected to external devices.
4.2.11 Setup KGC (GPS compass)
When connect KGC (KODEN GPS compass) to the SDME (ship
’s speed) port, please set KGC to set
format and output sentences.
Press MENU
key to display “Menu”.
Select [MAINTENANCE] => [I/O] => [KGC SET] => [INITIAL] => [GO], and press ENT key.
Data 1 or Data 2 in KGC-222 and SDME port of the radar are optimally set.