Koden MDC-5204, Installation Manual

Page: 93 / 182

MDC-5200/5500 Series Chapter 4 Setup after installation
0092655002-03 4-23
4.2.8 Setting of serial output
Following serial data sentences can be output from NMEA ports (J3, J5 or J6).
Note: OP1 and OP2 will be active when the junction box JB-35 is connected.
Make selection by following steps.
Select [MAINTENANCE] => [I/O] => [OUTPUT] => [OUTPUT J3], [OUTPUT J5], [OUTPUT J6],
[OUTPUT OP1] or [OUTPUT OP2].
Then indicate following submenu by move the trackball/joystick to the right.
4.2.8.1 Setting of TLL output
The position of marks and a cursor can be output to external devices.
Select the kinds of TLL sentences to be output.
(1) [MAINTENANCE] => [I/O] => [OUTPUT] => [TLL OUT] => Select [TT], [MARK] or [TARGET], and
press ENT key.
Set values: TT, MARK, TARGET
TT: The position of automatic tracking target captured is output with the cycle set in
“4.2.8 Setting of
serial output
”.
MARK: The positions marked in drawing will be output at every marking.
TARGET: TLL output is set on the function key. Every press of the function key allows the position of
cursor to be output as TLL on the screen.
Highlight numeral value and enter
desired period for desired sentence.
No output is available by 0.0 sec
setting.
ENT key press validates the value.
>OUTPUT J3 >OUTPUT xxxxx
xxxxx: J5, J6, OP1 or OP2
DTM 0.0sec DTM 0.0sec
EVE 1.0sec EVE 0.0sec
GLL 0.0sec GLL 0.0sec
HBT 5.0sec HBT 0.0sec
HDT 0.0sec HDT 0.0sec
OSD 1.0sec OSD 0.0sec
POS 0.0sec POS 0.0sec
ROT 0.0sec ROT 0.0sec
RSD 1.0sec RSD 0.0sec
THS 0.0sec THS 0.0sec
TLB 5.0sec TLB 0.0sec
TLL 0.0sec TLL 0.0sec
TTD 0.0sec TTD 0.0sec
TTM 0.0sec TTM 0.0sec
VBW 0.0sec VBW 0.0sec
VDR 0.0sec VDR 0.0sec
VHW 0.0sec VHW 0.0sec
VTG 0.0sec VTG 0.0sec
ZDA 0.0sec ZDA 0.0sec