Koden MDC-5204, Installation Manual

Page: 106 / 182

Chapter 4 Setup after installation MDC-5200/5500 Series
4-36 0092655002-03
4.6 TOTAL Hour and TX Hour (Cannot use while transmitting)
TOTAL HOUR menu indicates the total operating time of the radar.
Following operation can be used to reset total hours to 0.
(1) Press MENU key to display
“Menu”.
Select [MAINTENANCE] => [TOTAL HOUR] => [RESET] => and press ENT key.
TX HOUR menu indicates the total transmitting time of the radar.
This is useful information to use when exchanging radar parts. Use this hour information to judge
magnetron life expectancy.
Reset after components have been exchanged
(1) Press MENU key to display
“Menu”.
Select [MAINTENANCE] => [TX HOUR] => [RESET] => and press ENT key.
4.7 MENU Setup
MENU SETUP menu can be used to simplify full menu and turn off the items in full menu that are not
used. This is often used to remove not needed menu items for simple operation of the radar.
(1) Press MENU key to display
“Menu”.
Select [MAINTENANCE] => [MENU SETUP] => [GO] => and press ENT key.
Setup menu display will display.
(2) Select menu item to set ON or OFF => select [X] or [
○
] => and press ENT key.
(3) When setup finish, press MENU key. Menu display will disappear.
Press MENU key again. [X] mark menu items are not displayed.
Figure 4.8
>ECHO >ECHO
PICTURE MODE
×
IR OFF
PROCESS
×
VIDEO CONTRAST 3
EXPANSION
×
NOISE REJ OFF
IR
○
COLOR REJ >
VIDEO CONTRAST
○
SP/LP SP
NOISE REJ
○
PULSE WIDTH >
COLOR REJ ○ PICTURE RESET >
SP/LP
○
PULSE WIDTH
○
PICTURE RESET
○
PICTURE ENABLE
×
>ECHO
○