Koden MDC-5204, Installation Manual

Page: 86 / 182

Chapter 4 Setup after installation MDC-5200/5500 Series
4-16 0092655002-03
Input time difference between local time and UTC.
(1) Press MENU key to
display “Menu”.
Select [MAINTENANCE] => [I/O] => [TIME] => [TIME ZONE] => to highlight the value of [hour:
minute]. Move the trackball/joystick up or down to match it to the time difference, and then press
ENT key.
Note:
Display
“OWN SHIP INFO” method
(1) Press MENU
key to display “Menu”.
(2) Select [DISPLAY] => [ASSISTANT INFO DISP] => [LEFT], [CENTER] or [RIGHT] => [OWN SHIP
INFO].
4.2.2 How to use without NMEA input connection
To use the function of this radar effectivily, the default is set provided that all external input shall be
connected at the initial status. Therefore, when only basic function of radar (excluding navigation
function, mapping function, display of data, TT (ARPA) and AIS, etc.) will be used without connection to
other devices, an alarm with sound is displayed to remind an operator of input of ship
’s bearing, ship’s
speed and latitude and longitude. Please use this radar with keeping the ship
’s bearing, ship’s speed
and latitude and longitude OFF as follows.
Method of setting
Press MENU key to display
“Menu” and set as follows with the trackball/joystick.
When HDG is not input (GPS compass and GYRO are not connected):
(1) [ALARM] => [ALARM ON/OFF] => [I/O] => [HDG INPUT] => [OFF], and press ENT key.
When SPD is not input (LOG and GPS are not connected):
(1) [ALARM] => [ALARM ON/OFF] => [I/O] => [SPD INPUT] => [OFF], and press ENT key.
When LAT/LON is not input (GPS and PLOTTER are not connected):
(1) [ALARM] => [ALARM ON/OFF] => [I/O] => [LAT/LON INPUT] => [OFF], and press ENT key.
UTC or LOCAL
How to change
Move cursor on a grey item
UTC or LOCAL, and press
ENT key.
Date Time