Koden MDC-5204, Installation Manual

Page: 56 / 182

Chapter 3 Installation method MDC-5200/5500 Series
3-32 0092655002-03
Note: When mounting the Display unit on the tabletop, some maintenance space is required for cabling,
connector access, fuse replacement, fastening of bolts, etc. as shown in the following figure.
3.3.2.2 Table mounting of MRO-108
(1) Remove the corner guard caps (four places) on the Operation panel. Insert the tip of a small
flat-blade screwdriver carefully between a corner guard cap and the front bezel of Operation panel
to make a gap, and then pinch and pull up the corner guard cap with fingers. Take care not to
damage the bezel of Operation panel by the tip of flat-blade screwdriver.
(2) Remove M4 (4 mm) screws with which the Operation panel is secured to the mounting bracket and
remove the Operation panel from the bracket.
(3) Mark the place as shown in the following figure, and then secure the mounting bracket with 5M (5
mm) tapping screws (at four places).
(4) Secure the Operation panel to clamps with M4 (4 mm) screws that were removed in (2) and fit the
corner guard caps of the four corners.
Figure 3.11 Maintenance space requirements
Unit: mm (inch)