Koden KRD-10, Operation Manual, Page: 120 / 130

Chapter 7 Installation KRD-10
7-8 0093170212-01
7.7 Connection with external equipment (DATA1, DATA2)
KRD-10 has DATA1 (output) and DATA2 (input / output) of NMEA0183 / IEC61162 port for connecting
to external devices such as navigation equipment. A 6-pin water resistant connector and one end plain
(with ferrite core) cable (CW-376-1-5M) is supplied as a standard to connect to any devices, and cables
with connectors at both ends (CW-373-1-5M) is available as options.
Connection cable CW-376-1-5M has 6 wires and a shield wire around it. Signals are output from white
(TXD+) and red (TXD-), and signals are input from the orange (RXD+) and black (RXD-) lines.
Refer to the following for the connection of CW-376-1-5M.
When cables are connected to each other, please implement the waterproof and insulation treatment
on the connected part with the self-melting tape.
7.8 Inspection after installation
Before you turn the unit on, check the following points to make sure the system operates properly.
(1) Is the ship’s supply voltage and current within the rated range?
Voltage range : 10.8 to 31.2 VDC measured at the power connector input
Power consumption: 4.5 W
(2) Is the connection between the Display and Other unit correct?
(3) Are the cables routed and connected properly?
Structure of CW-376-1-5M
CAUTION
Wind the insulation tape around the un-used lead wire for core-wires not
to contact each other.
To external
equipment
6 +15V Output
（
Gleen
）
4 RXD+ (Orenge)
3 TXD- (Red)
2 TXD+ (White)
1 GND+SHIELD (Bule)
5 RXD- (Black)