Koden KRD-10, Operation Manual, Page: 114 / 130

Chapter 7 Installation KRD-10
7-2 0093170212-01
7.3 Siting the units
To achieve best operational performance, the following factors must be considered.
(1) The Display unit should be positioned in the location where the external situation can be viewed.
(2)
Locate the display so that it provides easy viewing from all likely operator’s positions.
(3) Select a position safe and free from dampness, water spray, rain and direct sunlight.
(4) Provide enough space for servicing. Consider access to the rear panel for connecting cables.
(5) Position the Display unit as possible away from other radio equipment.
7.4 Display unit installation
The Display unit is designed for table mount and flush mount. Refer to Figure 7.1, 7.2 or 7.3 for
installation.
7.4.1 Table mounting
(1) Remove the two knurled fixing knobs that fix the Display unit to the mounting bracket.
(2) Remove the Display unit from the bracket and place it on a flat and safe area.
(3) Place the mounting bracket to the place where the Display unit is to be installed, and fix the bracket
with four tapping screws.
(4) Reset the Display unit on to the bracket and fix it using the two knurled fixing knobs that were
removed in step (1). Refer to Figure 7.1 for detail.
Figure 7.1 Fitting detail of KRD-10 in table mounting mode
Unit: mm (inch)