Koden KRD-10, Operation Manual, Page: 101 / 130

KRD-10 Chapter 5 How to use LOP
0093170212-01 5-1
Chapter 5 How to use LOP
5.1 Initial setup for LOP display
Measured longitude and latitude can be translated into loran C, loran A or DECCA. To turn on the LOP
mode, the following initial setup is required.
5.1.1 Selecting LOP (Loran C, Loran A or DECCA)
Select the type to translate from longitude and latitude.
The procedure is as follows:
(1) Press key until Menu options 1 to 9 appears.
(2) Press key to select
“
7: Initial setup
”.
(3) Press key to select
“
4: Position
”.
(4)
Press [ ] or [ ] key to move cursor onto the “
Lop
”.
(5) Press key.
In the case
“LoranC”
(6) Press key to select
“
8: LOP
”.
(7)
Press [ ] or [ ] key to move cursor onto the “LoranC”.
(8) Press key.
(9) Press [ ] key to move cursor onto the
“
9: Chain
”.
(10) Input the station of LoranC by numeric keys.
7
4/W
MENU
ENT
NOTE: Press to backspace the
cursor to correct an input
error.
NOTE: Press to clear incorrect
Input. You can reenter
Numeric data.
CLR
Press
4/W
8/S
ENT
When serect Loran C, you must select station