Kimberley KARAVAN 2021, Installation, Maintenance & Operating Manual

Page: 29 / 120

29 ©2021 Kimberley Kampers Manufacturing Pty Ltd
WiTi Wireless Trailer Plug Connection with built-in Anti-theft & GPS tracking (Optional)
VEHICLE PREPARATION REQUIRED
IMPORTANT:
To use the WiTi system, the tow vehicle MUST be equipped with a 12 Pin Trailer Socket. The wiring
of the 12 pin socket on the tow vehicle must follow Australian wiring guidelines as shown below.
Pin 8 must be connected to a permanent power supply from the battery in the tow vehicle. It does not have to
be a high current supply as the WiTi Wireless Interface will draw very little current.
Pin 9 is optional and can be connected to an ignition source in the tow vehicle. This circuit works in
conjunction with the ignition output on the Anti-Theft unit. When the units are paired and the ignition is on in
the tow vehicle then the ignition output on the Anti-Theft Unit will provide 12V. The best way to describe this is
as a wireless relay. This connection can be used for any device on the caravan that requires an ignition trigger
for example DCDC charger, AES fridge or anti sway device in the caravan. This circuit is optional and does not
have to be connected if you are not using the ignition output on the Anti-Theft Unit.
NB. Not all vehicles are wired to Australian Standard VSB1 section 14 please test Pin 8 is 12V+
and Pin 9 is Ignition 12V+ before installing WiTi.
WiTi Wireless Trailer Plug Connection with built-in Anti-theft & GPS tracking (Optional)
WiTi Wireless Towing Interface and Communication Module Indicator Lights
There are two LEDs embedded in the WiTi Logo on the Wireless Towing Interface
and Communication Module.
When the unit is powered LED 1 (Red) will illuminate. When the unit is paired and
linked then LED 2 (orange) will illuminate.
Pairing a new WiTi Wireless Towing Interface and Communication Module
Ensure the WiTi Wireless Towing Interface and WiTi Communication Module are
plugged in and powered on (LED 1 is lit) and in range of each other - within 10
meters.
1. On the WiTi Wireless Towing Interface unit press and hold the “PAIR” Button
2. While the “PAIR” Button is still depressed, press the RESET Button for half a
second and then let go of the RESET button
3. When the RESET button is released, you will notice LED2 fl ashing rapidly while LED 1 is still solid. Let go of
the PAIR button. The WiTi Wireless Towing Interface is now in PAIRING mode. The unit will stay in pairing
mode for fi ve minutes while searching for the Wireless Communication Module.
4. Repeat the Pairing Process on the Communication Module in the Caravan or Trailer.
5. On successful pairing the WiTi LEDs will fl ash simultaneously for 5 seconds on both units to indicate that
they have successfully paired with each other. Once the LED’s stop fl ashing both units will exit PAIRING
Mode and return to normal operation. Both LED1 and LED2 will now be illuminated when they are in range
and powered.
6. If either unit did not detect a PAIRING partner during the pairing sequence, then LED 1 and LED 2 will fl ash
in an alternating sequence for 5 seconds (LED1-LED2-LED1-LED2) this indicates that pairing has failed and
the unit will then return to normal operation mode with just LED 1 illuminated. Repeat the pairing process.