Kikusui PLZ-30F, Operation Manuals

Page: 106 / 192

6-14 Remote Control PLZ-U
*RCL
Recalls the contents saved to the memory (0 to 3). The range of parameters that are
con
fi gured are the same as the range of parameters initialized by the *RST com-
mand. For a description of the commands that are affected, see appendix A.5, “SCPI
Command Reference.”
Set command: *RCL <value>
• Program data
Value 0 to 3: Memory number
Resolution 1
*RST
Resets the device to factory default settings. CONFIG number 1 and 9 to 11 in the
con
fi guration settings are not changed.
The settings after initialization are as follows:
Item PLZ150U PLZ70UA PLZ30F/PLZ50F
Current range H H -
Voltage range H H -
Operation mode CC CC -
CC mode SET value 0.000 A 0.000 A -
CR mode SET value 0.0 S 0.0 S -
CV mode SET value 157.50 V 157.50 V -
Switching function Off Off -
CC switching level 0 A 0 A -
CR switching level 0 S 0 S -
Switching frequency 1.000k Hz 1.000k Hz -
Switching duty cycle 50.0 % 50.0 % -
Slew rate 2.4 A/ μ s 1.2 A/ μ s -
Soft start 1.0 ms 1.0 ms -
OCP trip point 33.00 A 16.5 A -
OPP trip point 165.0 W 82.5 W -
UVP trip point Off Off -
LOAD OFF TIMER Off Off -
Sequence mode Off Off -
Operation mode CC CC
Current range H RANGE H RANGE
Step setting 0.000 A 0.000 A
Step execution time 0 ms 0 ms
RPT 1 1
SEQ STEP 1-256 0.000 A, 0 ms 0.000 A, 0 ms -
SEQ REPEAT 1 1 -
Load Off Off OFF
ENTRY - - CH1
INDEP Off Off -
DISP Voltage and current Voltage and current -