Kikusui PFX2500 Series, Operation Manual

Page: 48 / 144

48
PFX2512
Configuring the DC Power Supply
p. 70
If the DC power supply’s OVP or OCP is activated during a charge/discharge test, PS/B alarm occurs
on the PFX2512, and the output is turned off. Turn off the DC power supply, and eliminate the cause
of the alarm. Then, turn on the DC power supply, and clear the alarm from BPChecker3000.
For details on the setup procedure, a description of the alarm that occurs when a protection
function is activated, and how to clear the alarm, see the operation manual of the DC power supply
that you are using.
Setting the external analog control
Set the item concerning the external analog control to the following condition by using the
CONFIG setting.
For details on the setup procedure, see the operation manual of the DC power supply that you are
using.
Setting the Lock Function
Set the lock function to prevent settings from being changed.
See
PWR-01 CV control source: Control using an External voltage / External resistance (CF11: ON)
CC control source: Control using an external voltage/ external resistance (CF10: ON)
CV/ CC control range: HIGH range (CF12: HIGH)
External control for turning output on/ off: External control (CF14: ON)
External control logicof the output on/off: Turn the output on with a Low signal (CF15: LOW)
PWR CV control source: External voltage control (C-1: 1)
CC control source: External voltage control (C-2: 1)
External control logic of the output on/off: Turn the output on with a Low signal (C-6: 1)
PAS CV control source: External voltage control (DIGIT A: 1)
CC control source: External voltage control (DIGIT B: 1)
External control logicof the output on/off: Turn the output on with a Low signal (DIGIT F: 1)
PWR-01 Hold down LOCK (SHIFT+PWR DSPL) to lock or unlock. The LOCK LED is lit while the keys are
locked
PWR Hold down LOCK to lock or unlock. The LOCK switch is lit while the panel lock is enabled
PAS Hold down LOCK to lock or unlock. The LOCK switch is lit while the panel lock is enabled