Kikusui PFX2500 Series, Operation Manual

Page: 38 / 144

38
PFX2512
Connecting to the Electronic Load
3
Connect the other end of the cable with the solderless terminal to the output
terminal on the rear panel of the electronic load. The solderless terminal (M8)
with a red cap is connected to the DC INPUT + terminal, and the solderless
terminal (M8) with a white cap is connected to the DC INPUT -terminal.
Use the M8 screw set included with the SC05-PFX I/F cable for the PLZ-5W to make
the connections.
Connect the cables as perpendicular to the input terminals as possible.
To prevent interference with the cover for the load input terminals on the rear panel,
basically connect the solderless terminals in orientation (1) in the figure. If the
solderless terminals are small and cannot be connected in orientation (1), connect
them in orientation (2).
4
Place the bottom half of the cover for the load input terminals on the rear
panel underneath the cables connected to the load input terminals.
Orientation of solderless terminals
(1) Basic orientation
(2) If solderless terminal is small
M8 solderless
terminal
M8 solderless terminal
Screw (M8x18)
Tightening torque: 11.22 N
・ m
PLZ1205W example
PLZ1205W example