Kikusui PFX2500 Series, Operation Manual

Page: 111 / 144

PFX2512
111
7
8Slot Unit (
O
ption) /
V
o
lt
met
e
r Unit (
O
ption)
Connecting the DUT (Battery)
1
Check that the POWER switches of all connected devices are off.
p. 44
2
Connect DUT cables to the positive and negative DUT terminals of the
PFX2512.
Run the cables out as horizontal as possible, and fix them in place with screws.
3
Connect the other end of the DUT cables to the DUT (battery). Connect DUT +
to the positive terminal and DUT - to the negative terminal.
4
Insert the assembled cell voltage sensing cable connectors into the OP03-PFX
input terminals.
5
Connect the other end of the cell voltage sensing cables to the DUT (battery).
Connect the positive cell voltage sensing terminal to the DUT (battery)
positive terminal and the negative cell voltage sensing terminal to the DUT
(battery) negative terminal.
p. 42
6
Insert the assembled sensing connector into the PFX2512 SENSING connector.
7
Connect the voltage sensing cable to the DUT (battery).
WARNING
Risk of electric shock.
• Be sure to turn the SL01-PFX POWER switch off before connecting OP03-PFX units to the
DUT (battery).
• After connecting the devices, connect the OP03-PFX to the DUT (battery). Connect the
OP03-PFX side first.
CAUTION
• Risk of incorrect voltage measurement or malfunction. Be sure to connect the cell voltage sensing
cable to both ends of the cell. ( p. 130 )
• CC-CV, CP, and CP Pattern are controlled by the PFX2512 voltage sensing function. Be sure to
connect the PFX2512 cell voltage sensing cables to the DUT.
• Risk of damaging the DUT. If you leave the cell voltage sensing cables connected to the DUT, the
DUT will continue to discharge a minute current. (the input impedance of cell voltage sensing is
10 MΩ).
See
See
See