![background image](http://html.mh-extra.com/html/keithley/2520/2520_user-manual_661719073.webp)
Model 2520 User’s Manual
Basic Operation
3-13
Remote source and measure configuration
Source and measure configuration can also be performed via remote by sending appropri-
ate commands. The following paragraphs summarize these commands and give a simple
programming example.
Source and measure configuration commands
summarizes commands used for source and measure configuration. See
for more information on using these and other commands.
Table 3-4
Source and measure configuration commands
Command
Description
Configure measurements:
:SENSe[1]:VOLTage:RANGe <range>
:SENSe[1]:VOLTage:POLarity <polarity>
:SENSe2:CURRent:RANGe <range>
:SENSe2:CURRent:POLarity <polarity>
:SENSe3:CURRent:RANGe <range>
:SENSe3:CURRent:POLarity <polarity>
Configure sources:
:SOURce[1]:CURRent:MODE FIXed
:SOURce[1]:CURRent:RANGe <range>
:SOURce[1]:CURRent <current>
:SOURce[1]:CURRent:POLarity <polarity>
:SOURce[1]:VOLTage:PROTection <limit>
:SOURce[1]:FUNCtion <function>
:SOURce[1]:PULSe:DELay <delay>
:SOURce[1]:PULSe:WIDTh <width>
:SOURce[1]:CURRent:LOW <low_current>
:SOURce2:VOLTage <voltage>
:SOURce3:VOLTage <voltage>
Set laser diode voltage measure range (5 or 10).
Set laser diode measure polarity (POSitive or NEGative).
Set detector #1 measure range (0.01, 0.02, 0.05, 0.1).
Set detector #1 measure polarity.
Set detector #2 measure range (0.01, 0.02, 0.05, 0.1).
Set detector #2 measure polarity.
Select fixed (not sweep) laser diode current source mode.
Select laser diode source range (0.5 or 5).
Set laser diode source current (0 to +5.0).
1
Set laser diode source polarity (POSitive or NEGative).
Set laser source voltage compliance limit (1 to 10).
Select laser diode current source function (DC or PULSe).
Set laser diode source pulse delay (20e-6 to 0.5).
2
Set laser diode source pulse width (500e-9 to 5e-3).
2
Set low pulse amplitude for pulse mode (0 to 15e-3,
500mA range; 0 to 150e-3, 5A range).
Set detector #1 source voltage (0 to ±20).
Set detector #2 source voltage (0 to ±20).
1
5.0A maximum pulse mode only. 1A maximum in DC mode.
2
Settings affected by maximum duty cycle. See
.
Summary of Contents for 2520
