Operation Manual ServoOne Supply Unit
17
ID no.: 1101.21B.6-00 Date: 04/2020
NOTe:
Arrange the controller separated from the power area to prevent EMC
coupling mechanisms.
Control cables, signal cables and cable shields have been omitted for clarity.
y
Use bare metal backing plates.
y
The rear of the drive controller must have good contact to the switch cabinet
ground. The contact area must be bare metal to establish a good ground
connection to the switch cabinet ground. There must not be an air gap between
the rear wall of the drive controller and the wall of the switch cabinet.
y
The bases of the chokes must have good contact to the switch cabinet ground.
The contact area must be bare metal to establish a good ground connection to
the switch cabinet ground.
= 0 mm
1
2
> 0 mm
1
2
1) Bare metal backing plate
2) Large area contact
1) Paint
2) Air gap
Figure 3.2 CORRECT mounting of drive
controller
Figure 3.3 INCORRECT mounting of drive
controller
Mechanical installation
Summary of Contents for ServoOne Series
Page 6: ...Operation Manual ServoOne Supply Unit 6 ID no 1101 21B 6 00 Date 04 2020 Table of contents ...
Page 10: ...Operation Manual ServoOne Supply Unit 10 ID no 1101 21B 6 00 Date 04 2020 ...
Page 90: ...Operation Manual ServoOne Supply Unit 90 ID no 1101 21B 6 00 Date Date 04 2020 Glossary ...
Page 91: ...Operation Manual ServoOne Supply Unit 91 ID no 1101 21B 6 00 Date 04 2020 ...
