![background image](http://html1.mh-extra.com/html/kayo-moto/s200/s200_service-manual_3710754160.webp)
5 Engine
5-
92
Side clearance of piston ring groove
Standard:
The first ring groove (0.03-0.07) mm.
Second ring groove (0.02-0.06) mm.
Service limit:
The first ring groove of 0.10mm.
The second ring groove is 0.09mm.
5.8.10 Piston ring end clearance
inspection
Put the piston ring A into the cylinder, and use
the piston to position the piston ring to a
proper position. Set it near the bottom of the
cylinder, where there is less wear on the
cylinder.
Measure the clearance between the two ends
of the ring with a thickness gauge [B] piston
ring end clearance
Standard:
The first ring (0.15~0.35) mm.
The second ring (0.25-0.40) mm.
Oil ring (0.15~0.6) mm.
Service limit:
The first ring 0.55 mm.
The second ring is 0.60mm.
Oil ring 0.80mm.
★
If the end gap of any ring exceeds the usage
limit, replace all rings.
5.8.11 Wear inspection of piston,
piston pin, and connecting rod hole
★
Measure
the
inner diameter A
of the piston pin
holes at both ends.
·
Inner diameter of
piston pin hole
Standard:
15.002
~
15.008mm.
Summary of Contents for S200
