52
5 Engine
5-
Attention
Fill the bearing cavity with heat-resistant
230 ℃ lubricating grease.
·
Press a new needle bearing into the
driven fixed plate.
Tool - bearing pressure head.
·
Clean the grease and dirt from the
driven sliding plate and the driven fixed
plate. Then dry with a clean cloth.
·
Replace with a new O-ring A.
·
Apply lubricating oil to the new O-ring
and assemble it.
·
Apply grease to the oil seal lip.
·
Press oil seal B into the driven sliding
plate, with the oil seal end face flush
with the shaft end face C.
·
Assemble the driven sliding plate onto
the driven fixed plate.
·
Apply lubricating grease to the pin
shaft A and positioning pin B, and insert
them into the hole C of the driven fixed
plate.
·
Assemble the sealing ring.
·
Wipe off excess grease.
Attention
Be sure to clean the grease on the drive
disc.
·
Assemble the compression spring and
spring seat.
·
Align plane B of clutch drive plate A
with plane D of driven fixed plate C.
Attention
Be sure to use a clutch spring
compressor to avoid damage to the
compression spring.
Summary of Contents for S200
