Zhejiang Kayo Motor Co., Ltd.
5- 93
20mm C
Cylinder body diameter standard: (63.5-
63.51) mm
Service limit:63.57 mm
5.8.7 Piston wear inspection
·
Measure the outer diameter of the piston [A]
from the bottom of the piston up 12mm [B],
perpendicular to the direction of the piston pin hole
★
If the measured value exceeds the range of use,
replace the piston with a new one
Piston diameter standard:
(63.47
~
63.48)mm.
Service limit:
63.40mm
5.8.8 Clearance inspection between
piston and cylinder block
·
Subtracting the piston diameter from the
cylinder diameter to obtain the piston/cylinder gap
·
Piston/cylinder clearance
Standard: (0.02
~
0.04)mm.
★
If the gap exceeds the service limit, check the
piston and cylinder.
5.8.9 Wear inspection for piston
ring and piston ring groove
·
Check the wear
of piston ring bank
and ring groove
★
The piston ring
should
be
completely parallel
to
the
groove
surface.
If
not,
replace the piston
and all piston ring
·
When the piston ring is in the groove, use a
feeler gauge to make several measurements to
determine the piston ring/groove side clearance.
Summary of Contents for S200
