Zhejiang Kayo Motor Co., Ltd.
5-
Adjust valve clearance
·
Loosen the locking nut and rotate the
adjusting screw until the gap is correct;
·
Secure the adjusting screw B with
fixture A and tighten the locking nut C;
Tightening torque of the locking
nut: (12-18) N · m.
Tool - Adjusting screw fixture.
·
Recheck the valve clearance.
★
If the gap is not correct, readjust it.
★
If the clearance is correct, adjust the
clearance of the other valve.
Remove valve
·
Remove the cylinder head;
·
Mark the valve position so that it can be
assembled back to its original position;
·
Remove the valve using valve spring
compression device A and adapter B.
Tool - valve spring compression device;
-Adapter.
Assemble the valve
·
Replace the oil shield.
·
If a new valve is to be used, check the
clearance between the valve and the
valve guide.
·
If the gap is too large or too small,
replace the cylinder head.
·
Apply lubricating oil to the valve stem
and assemble the valve and spring lower
seat.
·
Assemble the spring with the sparse
coil facing upwards and the dense coil
facing downwards.
Valve A
Oil shield B
Summary of Contents for S200
