Zhejiang Kayo Motor Co., Ltd.
5-9
Engine
Material
Location
Remarks
Sealant Silicone
flat
sealant
Magneto rubber wire card
1512
gray
flat
adhesive
Assembly position of the left and right box
cylinder blocks
Before cylinder block
assembly
1271
thread
sealant
Main shaft bearing pressure plate bolt
Engine lubricating oil
The entire surface of the inner and outer
rotors of the lubricating oil pump
The entire surface of the rocker shaft
The inner surface and roller surface of the
rocker arm
The sliding surface and rod end of the valve
stem
The entire surface of the timing chain
The rolling surface of the camshaft
The inner surface of the cylinder borePiston
outer surface, piston pin hole and piston ring
groove
Outer surface of piston pin
Whole surface of piston ring
Shift shaft lever part
Starting the entire surface of the overrunning
clutch
The entire surface of the shift fork shaft
Side clearance of needle bearing at the large
end of crankshaft connecting rod
Inner hole at the small end of the crankshaft
connecting rod
Gear teeth (primary transmission, crankcase,
starting deceleration)
Sliding surface of disc teeth
Each bearing raceway and cage
Surface of each O-ring seal
Degreaser
Crankshaft and magneto cone
Summary of Contents for S200
