Zhejiang Kayo Motor Co., Ltd.
7- 7
7.9 Fuel sensor
Disassembly
Remove the 2 fuel sensor fastening
screws 1
Remove the sensor plug-in 3
Remove fuel sensor 2 from the fuel tank
Check
Connect the fuel sensor connector
Turn the ignition switch to ON
Shake the float of the fuel sensor by
hand to confirm its position and whether
the corresponding scale on the fuel
gauge is consistent
If there are inconsistencies, check if the
main cable is disconnected or short
circuited. If there are no abnormalities,
check the fuel sensor and fuel gauge
themselves
Connect a multimeter between the
terminals of the fuel sensor connector.
Shake the fuel sensor float by hand and
measure the resistance value at each
position of the float.
If there are any abnormalities in the
above inspection, replace the fuel sensor
Installation
Place the fuel sensor into the mounting
hole of the fuel tank and ensure it is
properly assembled without any oil
leakage.
Connect the fuel sensor connector.
Check the fuel gauge
Turn on the power and check if the fuel
gauge is working properly
After confirming that the fuel gauge
indicates normal operation, install the
body plastic parts and seat cushion in
the reverse order of disassembly
4
1
2
5
3
Summary of Contents for S200
