TaxLine IP Installation & User Guide
8
2.
Connection to the PBX via RJ45
Use the cable supplied to connect TaxLine IP to the LAN. Check with the network
administrator which IP configuration is adequate for TaxLine IP. Then, enter the
Configuration/System/Local Network for the configuration of the unit.
Also, in the PBX, you should input the IP address of TaxLine IP as the destination of
the call records.
3.
Connection to power supply
Connect the adapter supplied to the mains and to the POWER jack located at the
rear of the unit.
The unit must be connected to the mains in order to operate. The internal battery is
only used to power the memory, and to sustain the data and configuration in the case
of a mains failure.
2.2.
CONFIGURATION
When the unit is connected to the mains for the first time, the following screen
appears:
Version Number
:
TCP or RS-232 connection
mode to PBX
Ext:
maximum number
of extensions
INSTALLATION
TAXLINE 6.XXX TCP
ext:128 Call:10990
TARIFF DDMMYY
Calls:
maximum
number of calls
In the case of duration-based costing, indicates the
name of the tariff table present in the system and its
creation date.
If this screen does not appear, the system should be initialized again. Please refer to
the “resetting the unit” section in the Programming Guide.
Now a guided installation process shall start, allowing the unit to operate in standard
mode.
