Juniper JUNOSE 11.2.X BGP AND MPLS, Configuration Manual

Page: 605 / 742

Table 107: show mpls interface and show mpls l2transport interface
Output Fields
(continued)
Field Description Field Name
Entry index classifier-group entry
Number of packets and bytes on the interface packets, bytes
Name of profile rate-limit-profile
Number of packets and bytes that conform to the committed access
rate Committed
Number of packets and bytes that exceed the committed access
rate but conform to the peak access rate Conformed
Number of packets and bytes that exceed the peak access rate Exceeded
VC label sent by this router to upstream neighbor for route In label
VC label received by this router from downstream neighbor for route Out label
MPLS statistics for traffic received or sent MPLS statistics
Number of packets received or sent pkts
Number of high-capacity (64-bit) packets received or sent hcPkts
Number of octets received or sent octets
Number of high-capacity (64-bit) octets received or sent hcOctets
Number of packets that are dropped for some reason at receipt or
before being sent errors
Number of packets that are discarded because of lack of buffer
space at receipt or before being sent discardPkts
Interface specifier Interface
IP address of the remote PE router or name of the tunnel Remote-PE or LSP-name
VC ID number for the interface Virtual Circuit ID
Load-balancing group associated with the layer 2 Martini transport
circuit Load Balancing Group
Administrative state of the interface, enabled or disabled Admin state
Operational state of the interface, up or down Oper state
569 Copyright © 2010, Juniper Networks, Inc.
Chapter 10: Monitoring Layer 2 Services over MPLS