Juniper JUNOSE 11.2.X BGP AND MPLS, Configuration Manual

Page: 639 / 742

For instructions, see “Configuring the Loopback Interface and Router ID for VPLS”
on page 595.
6.
Configure MPLS LSPs to connect local and remote PE routers.
For instructions, see “Configuring MPLS LSPs for VPLS” on page 596.
7.
Set up LDP signaling for this VPLS instance to establish targeted sessions to the
remote PE neighbors configured at the edge of the MPLS core network.
8.
Configure an interior gateway protocol (IGP), such as Open Shortest Path First
(OSPF) or Intermediate System–to–Intermediate System (IS-IS), to enable routing
within the core network.
Related Topics Configuring VPLS Instances with LDP Signaling on page 603
•
•
Configuring Optional Attributes for VPLS Instances on page 593
•
Configuring VPLS Network Interfaces on page 594
•
Subscriber Policies for VPLS Network Interfaces Overview on page 577
•
Configuring the Loopback Interface and Router ID for VPLS on page 595
•
Configuring MPLS LSPs for VPLS on page 596
•
Configuring LDP Signaling for VPLS on page 604
•
Configuring Routing in the Core Network for VPLS on page 604
•
See Example: Configuring VPLS LDP Signaling on page 605 for a detailed sample
configuration.
Configuring VPLS Instances with LDP Signaling
As is the case with BGP signaling, when you use LDP signaling you must configure a VPLS
instance for each VPLS domain in which the router participates. Unlike BGP signaling,
however, configuring a VPLS instance for LDP signaling requires only that you specify
the transport virtual router for this instance by issuing the
bridge vpls
transport-virtual-router command.
To configure a basic VPLS instance with LDP signaling on the PE router:
•
From Global Configuration mode, create the VPLS instance by specifying the transport
virtual router for this instance.
host1(config)# bridge customer3 vpls transport-virtual-router vr1
The transport virtual router specifies the name of the virtual router on which the LDP
instance that signals reachability for this VPLS instance is configured. If the bridge
group you specify (customer3 in this example) already exists on the router, issuing this
command causes the bridge group to become a VPLS instance.
Related Topics Configuring VPLS with LDP Signaling on a PE Router on page 602
•
•
bridge vpls transport-virtual-router
603 Copyright © 2010, Juniper Networks, Inc.
Chapter 12: Configuring VPLS