Juniper JUNOSE 11.2.X BGP AND MPLS, Configuration Manual

Page: 56 / 742

Table 7: Commands Affecting the Current Address Family (continued)
maximum-paths bgp dampening
network bgp wait-on-end-of-rib
redistribute check-vpn-next-hops
table-map default-information originate
• The commands listed in Table 8 on page 20 configure parameters for a peer or peer
group, regardless of address family. If the peer or peer group is activated in more than
one address family, the values are changed in all those address families. These
commands are said to apply on a per-VRF basis. In the following example, EBGP
multihop is configured for the session, but when you configure an address family, it is
not available—that is, EBGP multihop is not configurable per address family:
host1(config-router)# neighbor 10.1.3.4 remote-as 1234
host1(config-router)# neighbor 10.2.3.4 ebgp-multihop 5
host1(config-router)# address-family ipv4 multicast
host1(config-router-af)# neighbor 10.2.3.4 ebgp-multihop ?
% Invalid input detected at '^' marker.
host1(config-router-af)#
exit-address-family
Table 8: Commands Affecting All Address Families for the Specified Peer
or Peer Group
neighbor maximum-update-size neighbor advertisement-interval
neighbor passive neighbor allow
neighbor password neighbor bfd-liveness-detection
neighbor peer-type neighbor capability
neighbor remote-as neighbor description
neighbor rib-out disable neighbor ebgp-multihop
neighbor shutdown neighbor graceful-restart
neighbor site-of-origin neighbor graceful-restart restart-time
neighbor timers neighbor graceful-restart
stalepaths-time
neighbor update-source neighbor ibgp-singlehop
neighbor weight neighbor lenient
• The commands listed in Table 9 on page 21 configure parameters separately for each
address family exchanged over the BGP session. If you configure these parameters for
Copyright © 2010, Juniper Networks, Inc. 20
JunosE 11.2.x BGP and MPLS Configuration Guide