Juniper JUNOSE 11.2.X BGP AND MPLS, Configuration Manual

Page: 603 / 742

This excerpt from the command output shows the label information displayed when a
circuit is up
host1# show mpls l2transport interface
...
Out Label 49 on tun mpls:lsp-de090100-24-37
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
queue 0: traffic class best-effort, bound to atm-vc ATM1/0.1
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
...
To display summary information about MPLS shim interfaces:
host1# show mpls interface shim brief
Remote-PE Virtual Load
or Circuit Balancing Admin Oper
Interface LSP-name ID Group state state
----------------- --------- ------- --------- ------- -----
FastEthernet2/0.1 222.9.1.3 200001 - enabled up
FastEthernet2/0.2 222.9.1.3 200002 - enabled up
Meaning Table 107 on page 567 lists the show mpls interface and show mpls l2transport interface
command output fields
Table 107: show mpls interface and show mpls l2transport interface
Output Fields
Field Description Field Name
Interface specifier MPLS shim interface
Address of the remote PE router for the layer 2 circuit Remote PE address
VC ID number for the interface Virtual circuit ID
Group ID number for the interface Group ID
Configuration of the control word Control word
Statement regarding configuration of sequence number Sequence number
Configuration of relay format Relay format
Starting and ending (inclusive) virtual path identifiers and virtual
circuit identifiers of the reserved VC range and whether the range
specification is activated on the line module for transportation of
ATM cells that belong to multiple VCs over a single pseudowire. ATM VPI/VCI range
Concatenation of multiple ATM cells to be sent in a single
MPLS-labeled packet for an ATM port, enabled or disabled. ATM cell aggregation
567 Copyright © 2010, Juniper Networks, Inc.
Chapter 10: Monitoring Layer 2 Services over MPLS