Jungheinrich DFG 316s, Operating Instructions Manual, Page: 84 / 187

85
05.10 EN
4.11 Lifting, transporting and depositing loads
WARNING!
Unsecured and incorrectly positioned loads can cause accidents
Before lifting a load unit the driver must make sure that it has been correctly palletised
and does not exceed the truck’s capacity.
X
Instruct other people to move out of the hazardous area of the truck. Stop working
with the truck if people do not leave the hazardous area.
X
Only carry loads that have been correctly secured and positioned. Use suitable
precautions to prevent parts of the load from tipping or falling down.
X
Do not transport loads other than on the authorised load handler.
X Damaged loads must not be transported.
X
If the stacked load obscures forward visibility, then you must reverse the truck.
X
Make sure you have enough visibility when reversing.
X Never exceed the maximum loads specified in the capacity chart.
X
Never stand underneath a raised load handler.
X
Do not stand on the load handler.
X Do not lift other people on the load handler.
X
Do not reach through the mast.
X
Check the fork spread before lifting the load and adjust if necessary.
X Insert the forks as far as possible underneath the load.
Lifting load units
Requirements
– Load unit correctly palletised.
– Fork spread for the pallet checked and adjusted if necessary.
– Load unit weight matches the truck's capacity.
– Forks evenly loaded for heavy loads.
Procedure
• Drive the truck carefully up to the pallet.
• Set the mast vertical.
• Slowly insert the forks into the pallet until the fork shank touches the pallet.
• Raise the load handler.
• Reverse carefully and slowly until the load unit is outside the storage area. Make
sure you have enough clear space to reverse into.