Jungheinrich DFG 316s, Operating Instructions Manual

Page: 139 / 187

05.10 EN
140
6.26
Check the attachment is properly secured to the truck and the
supporting elements.
t
6.27
Check bearing points, guides and stops for wear and damage,
grease and clean these components.
t
6.28 Check the hydraulic ports and tighten if necessary.
t
6.29 Check the cylinder seals.
t
6.30 Check the cylinder piston rods and bushings.
t
Maintenance intervals
Standard =
t
W A B C
Agreed performance levels
7.1 Carry out a test run with rated load.
t
7.2 Demonstration after servicing.
t
7.3 Lubricate the truck according to the lubrication schedule.
t
Maintenance intervals
Standard =
t
W A B C
Steering
8.1 Test the hydraulic steering and its components.
t
8.2 Test the hydraulic steering for leaks.
t
8.3 Check the steering axle and steering knuckle for wear and damage.
t
8.4 Check the stub axle and adjust if necessary.
t
8.5 Grease the steering axle.
t
8.6 Check the steer axle wheel bearings, adjust if necessary.
t
8.7 Check the mechanical parts of steering column.
t
Maintenance intervals
Standard =
t
W A B C
Hydraulic Operation