JUKI AMB-289, Engineer'S Manual

Page: 118 / 177

– 114 –
VCM control output offset
Tongue lifting amount
The button chuck height is adjustable
in accordance with the mechanically
elevated amount of the tongue.
Thread trimming control mode
: Thread trimming priority mode
: Cycle time priority mode
Button loader inserting height
compensation
Max. value of blindstitch width
setting
Bottom feed position of rear hole
of blindstitch
Bottom feed position from origin at
the rear hole of blindstitch is set.
Head tilt sensor detection ON/OFF
: OFF : ON
Head type
1
: Standard
2 to 9 : Unused
Each time origin retrieval
1 : Bottom feed only
2 : Bottom feed + needle rocking
3 : Bottom feed + thread drawing
4 : Bottom feed + needle r thread drawing
* Origin retrieval of bottom feed is performed only at
the time of sewing flat/wrapped-around button with
blindstitch.
Button loader lifting amount
Lifting amount after grasping button
is set.
Height from tongue stopper lower plate
Set this item when tongue stopper
parts are changed.
No. Item Settomg range Ddit unit Initia display Remarks
–30 to 30 1 0 *1
10.0 to 24.0 0.1mm 16.5mm *1
– – – – – –
Thread trimming
priority mode
10.0 to 25.0 0.1mm 17.0
0.0 to 6.0 0.2mm 1.6
0.0 to 2.0 0.1mm 1.5
– – – – – –
ON
1 to 9 1 1 *1
1 to 4 1 1
5.0 to 10.0 0.1mm 6.5
0 to 8.0 0.1mm 5.6 *1
*1 Data that have been memorized in the machine head EEP-ROM, and the adjustment value has been written at
the time of delivery.
2) Level 2
Memory switch data (level 2) can be edited when pressing MODE switch for as long as 6 seconds.
Position of the cloth presser at the time of manual
mode
: Up : Down
Waiting time before button holding
This item sets the waiting tiime before
button holding in the chuck.
No. Item Settomg range Ddit unit Initia display Remarks
– – – – – –
Up
0 to 2.0 0.1s 0.0s