JUKI AMB-289, Engineer'S Manual

Page: 93 / 177

– 89 –
3. Input of signal by means of the connector for external input
It is possible to input the signal from the outside.
When the switch is connected, it is possible to use as the input of the production control information.
For the details, refer to "Observing the production control information" of the Instruction Manual.
Cable (separately-sold) as shown in the figure below can
be connected.
(Caution) When the contact part becomes dirty, contact failure will be caused. Control so that the
contact part is not touched by hand, or that dust, oil or other foreign material does not
adhere to the contact part. Besides, be careful of handling the contact part since the inter-
nal element is broken by the static electricity or the like.
2m
3 2 1
1
2
3 +5V
SW
GND
Relay cable A (asm.) (40008168)
Connector housing : KYOCERA ELCO CO. 60-8263-3038-15-000
Pin contact : KYOCERA ELCO CO. 60-8263-0513-00-808
(Note) The switch main unit is not installed to the re-
lay cable A (asm.).